ts-h943 ms 25

[dbeerman27]

Ok i have flashed a benq fine and now I am trying to flash a ts-h943 f/w ms 25

I am runing xp
I have the rosewill rc 212 sata controller
Iprep v6
ok I go throuh i prep and make a bootable usb.. that works ok

Then I reboot my computer
hit esc to enter boot menu
move to usb
hit y to agree
type the command to dump I believe it is (dsam)
turn on my xbox and it freezes....

Ok I have also turned the xbox on before I turned on the computer and hit esc to boot menu and the sata card shows some kind of scan and says something about the bios then tells me to hit g to continue. When I did the benq it never did that. it never froze by turning the xbox on and off. after I hit g it allows me to go into the boot menu. I choose my usb

y to agree
dsam 1234567 12345
y the xbox is on
then it only shows ide not sata...

I have also tried to turn on the xbox after i go into the usb
y to agree
then I turn on the xbox and it freezes. I cant type nothing. Once again it never froze when it told me to turn the xbox on and off for the benq mod. I think that it is doing the scan again.

I tried to turn on the xbox while the computer was booting it froze and made a high pitched sound at me.

I watched the video tutorial from this site. its almost like the benq

everytime that I am going to mod an xbox i check to make sure my sata card is installed by checking the device mang.


Please help

i also posted this in the dvd drive modz fourm I thought I was in the beginners sorry

[CoFree]

dont have the 360 drive hook up till after you hit y that you agree.
then plug up the 360 drive to the sata and power it up
make sure that you loaded the right firmware for the samsung
you may have watched it but look over the video for the sam drive.
http://www.robinhoodsplayground.com/for ... =110&t=401

the sam are different the drive have to be on at first .to where the benq has to be off when you start.