Robin Hoods Playground

I flashed a Benq Drive just b4 xmas last year with ixtreme 1.4. using IPREP. If i understand it right the new games that will be coming out uses something like wave3???

What i need to know- Is the process of flashing the drive with the new firmware the same as if it had not been flashed before?

If so which is best version of IPREP is the best to use?

Would be greatfull for as much info as possible

Thanks

use RHPG iprep v009
http://www.robinhoodsplayground.com/for ... f=112&t=48" onclick="window.open(this.href);return false;
then just flash it like it was stock.
http://www.robinhoodsplayground.com/for ... 195&t=5129" onclick="window.open(this.href);return false;
dump
let firtool run
then flash
remember to make sure you have a backup of the orig firmware or the dvd drive key at the very least

CoFree wrote:use RHPG iprep v009
http://www.robinhoodsplayground.com/for ... f=112&t=48" onclick="window.open(this.href);return false;
then just flash it like it was stock.
http://www.robinhoodsplayground.com/for ... 195&t=5129" onclick="window.open(this.href);return false;
dump
let firtool run
then flash
remember to make sure you have a backup of the orig firmware or the dvd drive key at the very least

Thanks for the quick reply

I still have the original files from when i first flashed the drive when i brought it. does that version of i prep alow to use the new 1.51 firmware i heard that some wouldnt accept new firmware?

Yeah the version above supports the new 1.51. Alternatively if you already have a previous dump you could make your firmware in jungleflasher then rename it to bencfw.bin, put it in the backup/1234567/12345 folder and go straight to the fben command.

dalecheesy wrote:Alternatively if you already have a previous dump you could make your firmware in jungleflasher then rename it to bencfw.bin, put it in the backup/1234567/12345 folder and go straight to the fben command.

you could do that

but
imo
i think its better to stick with one program
unless you have problems.

well with IPREP all i got to do is load the firmware 1.51 to benq section create bootable usb!

1 then dben copy the data

2 fben to write

is this ok?

dben will dump drive and key,firmtool will make new cfw with your key,and then fben to write the firmware

so,yes you are correct.best of luck

cheers pal

its worked first time no errors at all thanks guys

good job man