Robin Hoods Playground

So, I got this Xbox 360. I'm using iprep 88. I was so Stupid! I assumed the box had a Lite-On drive inside but in fact it is a Benq. So I made the dump using dlit for lite one, and flashed it in as lite on with the CK3 and probe. The dump appears to be good. Then I flashed it as lite on, but now I have the e65. Since I made the dump as lite on is my original fw gone?
Assuming that the dump has a good key, How do I put it back onto the benq?

Help appreciated.

Check the key and you can create the benq cfw with JF. Just load the dump you made as souce then save the key.bin. Now load the ixtreme benq 1.51 as target, click manual spoof, click load key.bin and select you key.bin. As long as iPrep dumped a good key you should be alright.

then take the cfw that is in the backup folder out and put in your new bencfw.bin
and run the flash command again
it will flash in your new frimware and should get you going.