Page 1 of 1
Spoofed drive to 1.6
Posted: Sat May 16, 2009 2:46 am
by lennie paz
I replaced an MS28 with a spoofed BenQ.The BenQ is at firmware 1.51.How should I flash it to 1.6 being that it's spoofed?Should I just follow the tutorial for BenQ 1.51 using jungle flasher but use firmware 1.6?
Re: Spoofed drive to 1.6
Posted: Sat May 16, 2009 9:14 am
by technoe
Exactly, do it the same way as before just use 1.6
Re: Spoofed drive to 1.6
Posted: Sat May 16, 2009 9:37 am
by lennie paz
technoe wrote:Exactly, do it the same way as before just use 1.6
So even though I spoofed it to look like an MS28,I still flash it like a BenQ,right?Thank you
Re: Spoofed drive to 1.6
Posted: Sat May 16, 2009 9:50 am
by technoe
Yep use the benq firmware just make sure you use the sammy key. Did you save a copy of the 1.51 spoofed firmware, if so just load that as source, then the 1.6 as target and Spoof Source to Target, then write.
Re: Spoofed drive to 1.6
Posted: Sat May 16, 2009 10:03 am
by lennie paz
technoe wrote:Yep use the benq firmware just make sure you use the sammy key. Did you save a copy of the 1.51 spoofed firmware, if so just load that as source, then the 1.6 as target and Spoof Source to Target, then write.
I have the original spoofed BenQ bin and the original factory bin.