that would be spoofing.
you will need the v25 orig firmware (or cfw as long as it has a good key)
you will need to be able to flash a benq dvd drive
using jungle flasher put the v25 firmware as "source firmware"
then open the benq v1.6 firmware as "target firmware"
click the spoof to target.
click save to file
now here is where the road turns left or right.
i will go into doing it with RHPG Iprep v009
when you click save to file.
save it as "bencfw.bin"
now do this
make a iprep boot flash with RHPG Iprep v009
in the backup folder make a folder named 1234567
then in that folder make a folder named 12345
in that 2nd folder put the firmware you want to flash in(the firmware you just saved).It needs to named '"bencfw.bin "
with out the " " of course
then just flash it in like normal
boot on the flash and run the flash command
fben 1234567 12345
that will flash in a copy of your spoofed/hacked benq firmware.
you can have a look at this for the onscreen instructions that iprep will put up.
keep in mind when you are watching the video
you are only going to be doing the fben part so that is what to look for.
if you have any question just post up man.
