Robin Hoods Playground

im trying to flash a hitachi 79 and i get this



Mode-B Done!
Scanning for hardware changes
Scan returned an error!
Found drive C: - Hard Drive.
Found drive D: - Hard Drive.
No Hitachi drives were found!



what im i doing wrong?



im using a 32bit vista and using my sata via raid controller 3249

Did you turn the drive off and wait for the dots then turn it back on? Are you using a Ck3 or xbox to power?

do you have portIO32 installed? .....you cannot have the via drivers installed when you use JF. Has your setup ever worked? Please clarify your position so that we can help you.

im powering the drive with the xbox and i have never done a hitachi or used jf so im not sure if my setting are right i do have portio32 installed and my drive appears in jf but it says winapi i send mode b and it says hitachi found then i but flash ixtreme and my computer crashes can some one please let me know what im doing wrong thanks

I've never used PortIO when flashing a Hitachi drive. I've always had to use the WinAPI drivers. I've also had to refresh the drive list multiple times before the drive would show up. Also be very careful with your hitachi you can brick it fairly easy and then the only way to recover it is to pull the flash chip up and insert it into a PIC reader/writer.

technoe wrote:only way to recover it is to pull the flash chip up and insert it into a PIC reader/writer.

that in itself is a hard task to perform