Robin Hoods Playground

Here's my situation...

My 360(5th one)went down again..after rubber/penny then bolt clamp twice it finally seems as though Im wasting my time after 2 days of Arctic silver and screws......I have the original bin. file from it and i have just got a broken 360 and fixed it but seems like someone tried flashing it and made a mess..just says open/close tray....does not recognise cd's neither..

With it being dead could i spoof the key from my old TS-943 to the paggerd one???and if so what is the best method to go around doing this??

Any help would be greatly appreciated

Thankyou

as long as you have the key to the specific 360 you can put any drive in your 360.

What model drive are you replace, and what model you putting in??

I dont have the key to the 'working' xbox i just have an original bin. file from the broken one with the same model drive....seems i must need the key to the working one???.....but seems someone buggerd it up and bricked it......is there no way around this?

bloodyjudge wrote:I dont have the key to the 'working' xbox i just have an original bin. file from the broken one with the same model drive....seems i must need the key to the working one???.....but seems someone buggerd it up and bricked it......is there no way around this?

Sorry to say that the working 360, you will need that dvd key from the drive that came out of it. If you dont have the key then its usless as the key cannot be extraced from the motherboard.

Thankyou for the quick reply