Page 1 of 1
manually created hacked firmware
Posted: Mon Jan 07, 2008 2:52 am
by mrbooboo123
Hi, I just created a hacked firmware manually with the tut but I am unclear where to place it in my boot floppy disk. Can anyone explain?
Am I supposed to place this new manually hacked firmware into the the second of the two folders I create and name after my serial number on the boot disk under "backup?" Then boot and read, erase, flash?
Re: manually created hacked firmware
Posted: Mon Jan 07, 2008 11:00 am
by CoFree
well the way i do it is flash it in like the restore.
you would put it in the 2nd folder. the firmware you made needs to be named
" benq-ofw or sam-ofw "
the just run the restore and it will flash in the firmware you made.
viewtopic.php?f=110&t=196
Re: manually created hacked firmware
Posted: Tue Jan 08, 2008 4:00 am
by mrbooboo123
Thanks cofree! I got it to work on my Benq that was giving me a hard time. Your site is awesome...probably the best site I have seen for Xbox guides and discussion.
Re: manually created hacked firmware
Posted: Tue Jan 08, 2008 10:57 am
by CoFree
good job man
and thanks
Re: manually created hacked firmware
Posted: Tue Jan 08, 2008 2:49 pm
by Jman 31
mrbooboo123 wrote:Thanks cofree! I got it to work on my Benq that was giving me a hard time. Your site is awesome...probably the best site I have seen for Xbox guides and discussion.
What do you mean "probably"?
