Robin Hoods Playground

Ive got the latest 'frostythesnowman' disk to flash TS-H943.MS28...heres my shit....VIA card port is BC00 and i set the files(bin.)to C:/1111111 55555.........ive got the drive switched on with sata cable into via card....when i select the xtreme pri master...then power cycle the 360 it says error:fail open the output file????


Im getting really pissed off as i have done Benq drive with 1.4 a while ago.......iprep was playing up with me aswell...'no valid firmware loaded' even though i updated the XML. file in the x-projects folder...

Please help as im at my whit's end!!.,..thankyou

I'm not real familiar with the mod cd, but the ixdef.xml file goes in the resources folder of iPrep not the projects one.

Yhanks technoe....Jungleflasher...is MUCH easier than i thought...installed Port012 and sucess!!!....am amazed how much its moved on since boot maker and dosflash.........Job's a good'un!!!

Thankyou for the support!!!........you guys rock!