Page 1 of 1
restoring a benq
Posted: Thu Jul 16, 2009 11:40 am
by grandview
can you restore a benq back to O.F.W.? if so how? can i use Jf?
Re: restoring a benq
Posted: Thu Jul 16, 2009 12:49 pm
by cainhunpi
just dump the original firmware that you got before the first flash
Re: restoring a benq
Posted: Thu Jul 16, 2009 1:15 pm
by grandview
when i did it i used iprep but how do it with Jf...can you give me steps...do i put the ofw in both source and target
Re: restoring a benq
Posted: Thu Jul 16, 2009 2:55 pm
by cainhunpi
Souce = Old firmware in your computer's hard drive
target= the benq drive
Re: restoring a benq
Posted: Thu Jul 16, 2009 3:33 pm
by HaGGardSmurf
Just load your OFW as source, and target. Then flash it.
Re: restoring a benq
Posted: Thu Jul 16, 2009 8:17 pm
by grandview
thx
Re: restoring a benq
Posted: Sat Jan 16, 2010 1:14 pm
by meccs
I want to do the same. I loaded the original FW as source and target. I click WRITE and then it tells me I didn't spoof or something. I click ok and it writes and checks the FW. I click OUTRO and disconnect the drive.
But when I connect the 360 to my TV and put a original disc in it tells me "To play this disc, put it in an Xbox 360 console".
The original FW and the key are 100% good.