Robin Hoods Playground

I have the USB drivers it just wont dectect the probe atall. so i got an old RS232 at the moment i have a RS 232 cable from the CK3 pro into back of my PC.

I open Jungle flasher up and still no luck it just gives me a choice of Comport1 ;s

In CK tool when i scan all comports it does not recognise the Probe either on any ports.

The probe works in the fact its blue and goes green when its in the correct point on the dvd drive

agrrhhhh anyone any ideas?

Err i'm a bit confused. The probe isn't meant to show up in jungle or iprep it's just used for dumping the drive.

IT should show up on comport and give me the ability to tick the Box to use it according to the Tutorials?

the porbe should show as prolific usb serial device or somethin like that.

check that you have the correct drivers for it to show in JF,

Iprep you dont need any drivers just your rs232 cable and when setting iprep up make sure you have the correct com port