Robin Hoods Playground

I bought a pci sata controller card
I have done everything accord to every guide and i just cant make this "bad word" thing be detected >_>

Any suggestions?

I am using Iprep and when it get to detecting the Drive to dump it detect not ATAPI Devices. Any suggestions of help would be appreciated.

do you have the right controller selected in the drop down bar in iprep??

also do you have the sata cable plugged into the primary port and not any others on the card??

Mine wasnt there either on initial first look but try changing it to IDE based like I had to, Then if you click the dropdown you should then see your sata controller.