Robin Hoods Playground

i just flashed my benq drive and now it wont read anything not even regular xbox 360 games what can i do?

Check the OFW to see if they key is valid. if it is, restore it and start over.

how do you check that?

Open it up in JF, or in FW toolbox, and check to make sure the key is not 777777777777777 or FFFFFFFFFFFFFF or 00000000000000000 or something along those lines...

If it is a bunch of random non repeating letters & numbers, you have a good key. You can try to dump the FW from the drive, and check its key, you may have forgot to spoof.

Did you use iprep or JF? If you used JF do you have the log?

i used iprep but i just put it in jungle flasher and the key is valid

Now load your CFW and see if its the same key or something different. If its different, flash it back to the OFW and test it out. Then just start over from scratch to create a new CFW to flash it with.

it is the same now what do i do

i just have one more question if i have another benq drive could i just put it in that console and it work?

not unless it's the original drive or you have the original drive keys to flash into it

Same key but doesn't play games...
Does it play DVD's?
Did you buy this 360 online?
Did it used to play games & dvd's before you flashed it?