Page 1 of 1
Backup loader issues
Posted: Sat Aug 08, 2009 3:48 pm
by technoe
Ok guys here goes. I have a Wii 4.1u LU64 with Homebrew installed. My problem now is that I can not get any backup loader installed. I'm not sure what else I need to do.
Re: Backup loader issues
Posted: Sat Aug 08, 2009 3:55 pm
by rkd2398
You will need to put Wad manager 1.4 into the apps folder of your sd card. Then you add the wad that you want to load into the wad folder and you can install them there. Or you can get NeoGamma R7 and put that into the apps folder and run it straight from the HBC. Here is a link for NeoGamma :
http://gbatemp.net/index.php?download=6572
I think that's where I got it, or I can email you the zip I think its like 651 k. Let me know.
Re: Backup loader issues
Posted: Sat Aug 08, 2009 4:04 pm
by technoe
Well I used WadManager 1.5 and tried several different backup launchers I think I didn't label something right. I just re-downloaded some stuff from Yafaze and am getting ready to check it out.
Re: Backup loader issues
Posted: Sat Aug 08, 2009 6:09 pm
by sadalius
You could install cios corp and not worry about a backup loader and use the disk channel instead. There is a new version out now too. Yafaze is surely to have it by now.
Re: Backup loader issues
Posted: Sun Aug 09, 2009 10:48 am
by technoe
Man I feel so lost. I've been looking at all the stuff at Yafaze and I can't understand most of what I'm reading. Sadalius could you do a step by step for me. I'm terrified that I'm going to brick this sh*t.
Re: Backup loader issues
Posted: Sun Aug 09, 2009 11:24 am
by CoFree
man if you need call me
sadalius what do you think m
about asking those guys if we can use a few of there guides over here.
we would just move over the ones we need
Re: Backup loader issues
Posted: Sun Aug 09, 2009 12:36 pm
by technoe
Will do man. Thanks.
Re: Backup loader issues
Posted: Sun Aug 09, 2009 8:00 pm
by sadalius
Here is the install instructions for the new cioscorp. It is very straight forward to install and if you want to run gamecube backups, it has that capability too. If you want to try it, just go to wiinewz.com, its on the front page.
How to install it:
Unpack the contents of this .zip file to your SD card and run the
"cIOSCORP v3.2 Installer" application via the Homebrew Channel,
sit back, and wait a few minutes. That's it!
If you want to load backup GameCube games aswell, then run the
"cmios Installer" application via the Homebrew Channel, after
installing cIOSCORP v3.2. If you already have a cmios and don't
want to change it, then don't run "cmios Installer".