Robin Hoods Playground

I have installed the NEW iPrep and went to run it.....

I get the error "no valid firmware loaded" when I try to load the 7000 lite-on or the 8000 lite-on it loads samsung and Benq just fine.

I know my firmware is correct as I have flashed both drives (7000/8000 series lite-on) am I holding my mouth wrong over here?

Rats...I am so excited I just want to flash the 8000 with iPrep.

It loads fine fw's fine for me. Check your ixdef.xml file and compare the md5 checksums to see where the problem might be.

Did you get this figured out shootsteel?

The only thing could be the md5's Open the idef file with notepad, and look for the FW in the list.