Robin Hoods Playground

I have gotten the key, by using jungleflasher and the probe, but my pc froze during the erase. So rebooted and erased it again and got it into vendor mode. Then i select the dummy.bin and spoof the autoloaded liteon FW(ix 1.6), and checks that the key matches. Now it is saying that flash is okay and so on, when i write the new fw, and i then "ata reset" and plug it in to the xbox.

Eject button works fine, but the problem is when i put a disk into the drive, it spins REALLY REALLY fast, and in the dashboard it says "Reading", then i press the eject button and the drive stops spinning and ejects. But it is spinning so fast that the disk is still spinning when the tray opens.

I have also tried to flash it using iprep, and it also said it went fine, but still same problem.

Would could have went wrong?

Does it play the original or backup at all? Maybe trying to re-flash it.

rkd2398 wrote:Does it play the original or backup at all? Maybe trying to re-flash it.

As stated, in my post.

I have reflashed it, it doesn't play games(just says "reading" in the dashboard)
, and spins very fast, so fast that the disk still spins after the tray is ejected.