Page 1 of 1
benq vad6038 with iprep 10.7 help
Posted: Thu Sep 24, 2009 6:00 pm
by sesmm123
I have a benq vad6038 drive and i made the bootusb and it loaded fine. I have my 360 drive hooked to my motherboard via sata and the drive is recognized in windows. I am using the 360's power unit. I got to the page where it says type "y" and power cycle the drive so i clicked y and enter and it says status 0xD0 and it doesnt move. i unplugged the drives power and plugged it back in very fast. i retryed this like 100 times. i read the tutorials so many times and watched a video but i cant find anyone with this problem. any thoughts?
Re: benq vad6038 with iprep 10.7 help
Posted: Thu Sep 24, 2009 10:40 pm
by iamwatt
probably be best to invest in a connectivity kit
Re: benq vad6038 with iprep 10.7 help
Posted: Sat Sep 26, 2009 2:12 pm
by Tadmen
I had a problem with iPrep 10.7 and benq. Thought I bricked the drive, because it was really slow loading etc. The banks reading took minutes. Then I remebered that I should boot my comp with the usb stick connected and with the sata connector "NOT CONNECTED" to the drive. The power to the drive was ON. When I got to the iPrep screen it all went really fast (unlike before). Only then I connected the sata cable. From then on it worked like a miracle.
Try it
(at your own risk
Re: benq vad6038 with iprep 10.7 help
Posted: Mon Sep 28, 2009 10:08 am
by lilrevuk
What sata are you using?
I couldn't get the correct response no matter what I tried with an ICHX chipset, yet VIA got the correct status first time...
Re: benq vad6038 with iprep 10.7 help
Posted: Tue Sep 29, 2009 9:13 pm
by sesmm123
im not sure waht sata im using. i will have to ask my friend cuz its his computer. When did u say u plugged the sata back in. after u typed "y" and clicked enter?
Re: benq vad6038 with iprep 10.7 help
Posted: Thu Oct 01, 2009 11:31 pm
by sesmm123
anyone?