Robin Hoods Playground

Hello,
I am trying to flash a samsung drive with jungle flasher 1.66, the problem is it wont detect my drive. I power it on, turn off, slide half way in, and turn it back on and open jungle flasher. I then go to the flashing tab and select the right I/O port for my via pci card. But for all the ports it says no drive detected! Please Help

Do u have portI0 drivers installed??

I have port IO32 installed

Ok thats good then
What sata card are u sing mate?

DJ

VIA VT6421A 3-Port SATA Raid & IDE Controller PCI Card

It could be a bios setting that is not properly set for example I got a new mobo a few weeks ago and it has several modes for sata, VIA, AHCI, and SATA. By default AHCI was enabled and I too could not get drives recognized, then I enabled the SATA mode and it went smooth from there. Also try to make sure you are using the primary sata port that seems to be very important. I hate those Via cards but Ive been able to use native sata on a bunch of mobos just making sure to use the primary port. Hope that helps