My problem is when it asks you make sure you xbox is on and then hit enter...it should go to the MTK thing....but instead it goes straight to Reading Bank 0, and i only get like 3 dots into that
note: my drive is already in vendor mode, with a parallel flash 0x70, atleast thats what JF tells me...
any help would be awesome
i am using the VIA card that everyone has
Iprep 10.7 problem
-
commando_lee
- Ally of Robinhood
- Posts: 1821
- Joined: Sun Apr 26, 2009 12:50 pm
- Location: Up high in the tree looking out for the Sheriff of Nottingham
Re: Iprep 10.7 problem
you need to give us more info. what drive? what command did you give?, where does it stop? what error? the more info the more answers
................................................................RobinHoods Very Own
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.
Re: Iprep 10.7 problem
Its a ben q VAD6038, its the screen right after you enter you serial number, where it just tells you to hit enter to continue, in the vid tut...the MTK vendor thing pops up, but mine just said Reading Bank 0...then did nothing....
Re: Iprep 10.7 problem
Make sure you have the right sata port specified when you setup iprep.
Sadalius
No questions by PM please
No questions by PM please