Robin Hoods Playground

I have used Iprep for long time and when I now start using Iprep 10.7 I wonder one thing.

Before I could choose if I wanted to dump or flash (example DSAM, FSAM). Now I only have SAM and then it starts to run dump. I have already got an correct dump of the firmware and now just want to flash the drive.

I write SAM 1234567 12345 (I have samofw.bin in the 12345 folder)

Then i get:

Directory already exists
Directory already exists

**** ERROR ****

BACKUPS\xxxxxxx\xxxxx\samofw.bin already exists
Process aborted.

How can I flash the drive when I already have dumped the key before? The drive is unindenfied so I cannot dump it again.

as long as you have already have the samofw.bin in the backups/1234567/12345

then you can just do this command at the first prompt

sam 1234567 12345 w

that will take you to the write command strait away