Robin Hoods Playground

Hi,
After following the iprep and creating my usb boot disc, and following the on screen insturctions the drive wont be read. This is what happens:-

1) First off turn on xbox and the pc, programs runs and going striaght into reading the drive, and then comes up with error at the end.
2) Power on pc and not the xbox, run the program and it waits for the xbox and once the xbox is turn on, it goes striaght into reading and still comes up with an error. It just wont read it.

Any ideas?

well we need to know more about your set up
if you are not using a via card
you need to with iprep and a benq

if you are and its just not seeing you benq drive
D1 not flashing (for BenQ) :
What that means is the computer is not seeing the 360 drive.There are many different thing that can be causing this problem.
Chipset will not work.Most sata ports on the mobo will not work.
Try a different port on your sata card.The port closest to the front most of the time is the one to use.
Try a different sata card.This a card that is known to work
http://tekgems.com/Products/la-pci22-vt6421a.htm" onclick="window.open(this.href);return false;
Try a different sata cable
Put the sata card in a different pci slot
I would try this just for kicks before the next step.Try a floppy maybe that will do it (don't hold your breath)
You may even need to try a different computer.This is rare how ever it will happen some time.

you can find that info here
http://www.robinhoodsplayground.com/for ... f=63&t=324" onclick="window.open(this.href);return false;