Robin Hoods Playground

First off,

I am still pretty much a newb at this. When everything runs smooth i can mod a BenQ or Samsung, pretty easily (I know impressive huh jk). But yesterday I was updating my BenQ iXtreme 1.6 firmware to 1.61 using iPrep 10.7. When my power went out. This happened right after iPrep erased the firmware, I have been trying to add new firmware but am getting an error. Stating the back ups are not correct.

I am away from CPU that I flash my 360 on.

I am using iPrep and not jungleflasher because I have a 64bit operating system

In hindsight It could be possible that it is finding my harddrive believe it is finding my hard drive and not the BenQ drive. Is this possible? When I start the CPU and load the boot screen, it does not see the BenQ drive. Is there a fix to this or am I SOL

you have to restore the benq
have a read over this
http://www.robinhoodsplayground.com/for ... =197&t=196" onclick="window.open(this.href);return false;

if you dont have the key that was originally in the dvd drive firmware
then its game over man
its bricked for that console

it can be used for a spare drive though

"it can be used for a spare drive though"

lol that would suck.. haha

CoFree wrote:you have to restore the benq
have a read over this
http://www.robinhoodsplayground.com/for ... =197&t=196" onclick="window.open(this.href);return false;

if you dont have the key that was originally in the dvd drive firmware
then its game over man
its bricked for that console

it can be used for a spare drive though

I have the Key written down because I am parnoid like that.

Is it possible to do what you suggested in the link on iPrep? I have a 64 bit operating system.

Or

Is there a way to get I Jungleflasher to work on a 64bit operating system (other forums say no.)?