replacing a liteon drive with a benq

[ray]

hi guys,want to replace a liteon drive with a benq,i already have the key from the liteon as i flashed it before with jungleflasher,so the files i have are the key bin,inquiry bin,identify bin,and dummy bin,can i use this information in an older version of iprep and just write to the benq drive or do i need jungleflasher if so can someone give me a guide in the right direction to spoofing the liteon information to the benq,thanks

[docwarbucks]

in jungleflasher open the ben q half open tray and power on
2 click intro to device .follow the screen command to power off than on
3 load lite on dummy bin as your source firmware
4 load target firmware which would be benq
5 hit "spoof source to target"
6 save and then write your firmware
7 click outro

[ray]

guys,using jungle flasher for the above steps all is well till i hit write and i get an error message invalid status 080 and also had invalid status 051,any ideas what is wrong?once i create the cfw in jungleflasher can i use an older version of iprep and use the write command to flash the drive by putting the cfw that jungleflasher made in 1234567 12345 folder,many thanks