ISO's and Stealth

[xen_au]

I know this is a newbie question, but after the recent bannings I've got confused about how to check if a ISO is correctly stealthed.

I have a BenQ drive flashed with iXtreme 1.4 (12x Speed).

Once I have an ISO on my computer, how do i check if it has been correctly stealthed?
Do I just use Mulleter?
Do I need to check the ss.bin for the jitter issue?
Has 1.4 fixed the jitter issue so you can use ISO's with a 'bad' jitter number?
Can I use any game that was correctly stealthed the old way now that iXtreme 1.4 is out or are the 'bad' copies still bad?

Any help would be great, after the recent banning these is so much information floating round I got competely lost.

[CoFree]

you can use xbc v2.6/2.7 or mulleter 10
with xbc you click the image tools tab
now click the stealth check
go to your iso
it should all be green
the split vid can have a question mark it should be fine.when you dump your iso i would start dumping with split vid checked.

for getting the ss and checking it do this.
http://www.robinhoodsplayground.com/for ... =110&t=261
you would use the image tad not the drive if its a iso on your computer not a disc.

i would not use a game that has a bad ss.even with the new v1.4 firmware .why take a chance.

[xen_au]

Thanks for the advice cofree.

Is there a way to turn a bad rip into a good one?
Such as replacing the SS.bin?
Or will I need to obtain a different enitre new ISO?

[CoFree]

you can try with mulleter10
use this guide just start at the mulleter part.
http://www.robinhoodsplayground.com/for ... =110&t=153

the thing is i would not trust that iso even if mulleter fixed it.