trouble with liteon please help

[imastud]

hello just got my 360 back from ms and used jf to extract the key also used it to build a hacked f/w lite_cfw.bin

now this is where i have trouble because jf locked up on me i wanted to erase in dos so i followed cofree guide useing l-o-eras.exe that bit worked now when i go to write i follow the guide type in the name of the hacked f/w lite_cfw.bin press enter then it starts to write the first bank then comes back with an error saying drive A not ready can anyone help please

i know i have the port right checked it in iprep e800 it said

so i typed in l-o-eras.exe e800

and like i said above that part works fine

the tured off the drive typed dosflash and a list of drives appear the liteon drive is the first number 0 i know this because i can see my port number

please can antone help im going crazy hear

btw im using a via card the same card that i flashed my benq drive
and a ck3 to power the drive

[sadalius]

Try going into your BIOS setup and temporarily disabling floppy drive support. That way it won't look for the A drive. Unless it's assigning A to your boot media, which it shouldn't be unless your using a floppy disk to boot from. In which case, if you are using a floppy disk, try a different disk.

[imastud]

thanks for the reply

i have tryed that same thing is happening but now when i do the same thing after i have done the i-o-eras it does,nt let me choose my drive just keeps on saying mtk vendor failed then goes to d51 status also i have put the drive back in the xbox and when i turn it on it wont eject and the middle light on the green ring flashes really fast and after a few seconds i get a red light in the botton right quadrant

is the drive bricked, is it worth sending it back to ms i still have the warrenty stiker

[sadalius]

Did you get they key.bin, identity.bin and the inquiry.bin files? If you didn't, then it's game over, the drives been erased and has no dvd key.

If you did, then you can still flash it. You might have to use doshflash by itself to flash the lite_cfw.bin file to it, if you've got that file that is.

[imastud]

got it working now,had to uninstall the via drivers then boot into dos run the l-o-erse command until i got the ff72 status the booted back into windows and done the rest with jf


thanks for your help

[sadalius]

Cool, glad you got it. I wasn't aware that you could l-o-erase a lite-on and then use jungleflasher to finish with. Wow, learn something new every day, thanks!!

[CoFree]

yep
i like that
thats a good post there man
thanks

[imastud]

i would have liked to do the whole thing with iprep and my probe watched your video(which is the best i have seen btw) but i would,nt let me extract the key keep on getting errors so i just used jf for the key grab


Is there any chance you could make a video using the probe instead of the soldered method

again thanks for all your help

[CoFree]

yea
im going to do a new set of videos on flash

[sadalius]

My video uses the probe, but where I couldn't use a video camera, you just can't physically see that part and also, it only shows using jungleflasher and not iprep.

[peacock]

got it working now,had to uninstall the via drivers then boot into dos run the l-o-erse command until i got the ff72 status the booted back into windows and done the rest with jf


thanks for your help

think i might try that..