lite on not responding

[jabba]

iv been tryin all day 2 flash my lite on i have a ck3 and probe i used iprep got the key out with prob then i booted in 2 windows 2 save the files then booted back up in iprep and when i started the flash it erased but didnt flash now my lite on wont eject is there any think i can do 2 gt it going again

[cyantific]

Just make sure your Lite_CFW.bin is on the USB key and run dLit again. Or, you can try using dosflash m8.

Put dosflash on the USB stick and when you get into the DOS prompt, type in l-o-eras sataport COM# (ex l-o-eras ec00 1)

Do this twice and if you don't get FF72 then turn the ck3 off and on. Then do it two more times and on the second time you should get FF72. Then turn your ck3 back off and type dosflash. It will find the drive and hit Y to send the Unlock command (your ck3 should be off). Then turn it back on while its sending the code and it will pick it up. Select the right # again from the drive list and hit W to write and put in lite_cfw.bin.


Of course lite_cfw.bin needs to be in the main directory of the USB stick and not in your serial folder. This is how I flash lite-on drives to the T.

[CoFree]

if you are using iprep8.8
the file name will be litcfw.bin there is not a - in it.

[jabba]

when i run dlit will i need 2 reconect my probe

[cyantific]

if you are using iprep8.8
the file name will be litcfw.bin there is not a - in it.

Ah JungleFlasher uses the Litw_CFW.bin. Thanks for pointing that out.



If you want to run dLite you will need to dump your key by using your probe.

[sadalius]

If you've already got your key and it's made the custom firmware, you need to run the flit command and not the dlit. If it's erased, dlit won't work anyway because it's erased, nothing there to read. If you don't have your custom firmware, used jungleflasher to make the custom firmware. Just make sure to load your dummy.bin as the source, then load the ixtreme 1.5 as the target, spoof the source to the target and save the file as litecfw.bin, put the litecfw.bin file into the backups folder under your serials, then use the flit command to finish the flash.

[jabba]

yes its workin now thanks 4 the help lads

[sadalius]

good work jabba, I knew you could do it!!