samsung m28

[welshgirl]

hi all trying to flash my samsung m28 drive all im getting is post 8000 master/slave a0 nothing else likes its hanging there
any info on this guys cheers ........

[Jman 31]

We'll need a little more info. Tell us what you used to make your boot disk, The type of sata card you have, what programs you are using and you should take a look at this if you haven't already: http://www.robinhoodsplayground.com/for ... =110&t=401

[welshgirl]

hi thanks for the reply software im using is iPrep 101ve r06 with Samsung.iXtreme.1.4 and the card is VIA VT6421A ............. and a usb mermory card reader ........

[Jman 31]

At what point are you getting that error. What I'm getting at is, what steps have you gone through to get to the point where the error occurs? Also, did you update the def file in iprep?

[welshgirl]

after idump all i get is post 8000 master/slave a0 thanks once again for helpin me ....

[CoFree]

well im not sure what you are doing
you should be putting in dsam 1234567 12345 (that would be your ser number) that is if your are trying to dump a sam drive.
with the lastest iprep101 v006
if you are not getting xtreme pri master then the computer is not seeing the 360 dvd drive.

[welshgirl]

dsam 1234567 12345 ive put that in and it is seeing me drive i did the wait 10 sec trick and so on........

[CoFree]

your powering off the driver and on at the right time.
have you watched the video.
http://www.robinhoodsplayground.com/for ... =110&t=401

so it will show you xtreme pri master
then there is problem with your sata card or your usb flash or the computer
if you can try a floppy drive try that

[welshgirl]

thanks for the help i will try again and let you know have a nice xmas and new year.......

[irishjoe]

Try changing the sata port that you are plugging the wire into on the VIA card. I was using the wrong port and it wasn't working. Use the one nearest the front of your computer case. When I did that, it flashed perfectly...

[welshgirl]

just watched the video and flashed it in no time wow thanks alot for your help.............

[CoFree]

glad to help