possable broken samsung drive

[SUPERCELL]

I have a question about my samsung drive i was trying to flash my samsung with the latest firmware when somthing went wrong and now i cant get any power to the drive it wont eject or show up in iprep and i dont know why i don't know if it is bricked or if it is a paper wait now . Is there any way to possible get the samsung drive to work again it is not the xbox 360 because i tried a another drive and it works i tried to use the MTKFlash but cant find the right version is there any way to test the drive to see if it is the board

[technoe]

As long as you have a good copy of the key, you can save the drive. And iPrep will be the easiest way to do it, IF you remember which port you were connected to when tried to flash it the first time.

[SUPERCELL]

my samsung will not show up on any port iprep keeps searching for it but cant i know it is not my sata cable or my sata card because i have flashed tow other drives with it . even tried to flash it on another computer still no go like i said i tried the MTKFlash but canted get it to work is there any good bad flash tutorials out there that i can read up on how to do it. will extreme boot maker work.symptoms no power
wont eject
wont show up in iprep just get error

[Shootsteel]

this sounds like you plugged in the power sata upside down, if thats the case then I don't think you have any recourse with this drive.

[CoFree]

when you put this drive back in the 360
it want do anything
even with a bad firmware in it it should open and play dvd movies

if it want the shootsteel is right
it sounds like game over for that drive
and if you dont have the key from it the its game over for the console also.
sorry

[SUPERCELL]

yes i have the key and a new drive i was trying to fix this one for a back up drive and everything was pluged in right. in the box or out of the box i get no power at all to the drive i dont no what went roung i have flashed this drive three times till this last time when i got the red lights of death then i fixed that went to flash the drive and nothing no power at all doesnt show up in iprep .Is there a way to test this drive to see if the board is dead
And thanks for the help so far

[technoe]

Then you probably plugged the power cable in upside down, when you had your drive hooked up inside the drive. the 3 red rings will show up instantly if you do that.