Spoofed drive to 1.6

[lennie paz]

I replaced an MS28 with a spoofed BenQ.The BenQ is at firmware 1.51.How should I flash it to 1.6 being that it's spoofed?Should I just follow the tutorial for BenQ 1.51 using jungle flasher but use firmware 1.6?

[technoe]

Exactly, do it the same way as before just use 1.6

[lennie paz]

Exactly, do it the same way as before just use 1.6

So even though I spoofed it to look like an MS28,I still flash it like a BenQ,right?Thank you

[technoe]

Yep use the benq firmware just make sure you use the sammy key. Did you save a copy of the 1.51 spoofed firmware, if so just load that as source, then the 1.6 as target and Spoof Source to Target, then write.

[lennie paz]

Yep use the benq firmware just make sure you use the sammy key. Did you save a copy of the 1.51 spoofed firmware, if so just load that as source, then the 1.6 as target and Spoof Source to Target, then write.

I have the original spoofed BenQ bin and the original factory bin.