weird issue with a benq

[ceril]

I updated a benq from 1.4 to 1.6 every went ok until verifying the flash, it failed. I went and hit outro and it just hung so i turned the 360 off and back on. There was a backup in the drive and it read the backup fine but it wont eject. When I hit the eject button it flashes but doesnt eject. I am trying to reflash now but i am getting errors. Ill get the exact error. It reconizes the 360 drive in JF still but I have to do the power off/on now beacuse it has ixtreme 1.6 on it. I have the OFW so I think I should be able to fix it right?

[lcddarkangel1]

yeah you should as long as you have the ofw and the correct key for it.

i been there too

[ceril]

I had my viaraid.sys files installed to do hitatchis. i disabled them now
I am able to reflash the drive but it still will not eject. any ideas?

I have actually put it back to stock and it still will not eject. I dont understand whats going on.
Perhaps a bad key?

[lcddarkangel1]

did you use 79 unlock?

[ceril]

For a benq? no. i used benq unlock etc. its very weird. i went though the initial startup again and it seems to be working. i flashed the drvie back to stock then with 1.6 and did the update. the drive it working but it sounds a but weird when it closes the tray. not sure if there is something wrong with this. drive. i will try to play with it more.. when there is no dvd in the drive either real or backup it doesnt want to open all the time. it flashes but doesnt open after the 2nd or 3rd try it then opens. with a dvd in it open and closes fine. not sure may be a bunk drive, i need to talk to my cousin to see if he had this issue before or if something i did broke it.

[ceril]

I got it squared away. one of those tabs that holds the dvd drive in place was keeping the drive from closing.. but its sorted now. thx!!!

[technoe]

Good deal man, that was a rare scenario!!