OMG I think I got lucky

[calishooter]

When i unlocked my benq (using power supply from my xbox360,using jungleflasher,VIA 6421 sata card drivers installed,portio32 drivers installed,.net framework 2.0 installed)why did my computer start acting up?(It would freeze like every 5 seconds)So I continued flashing fearing i would loose my key.(I didnt) My write verify failed.I hooked everything back up,played a back up copy of one of my games to see if i messed up my drive(Benq drive)and it played. Will this(write verify failed)bite me in the butt later on or did i just get lucky?

Auto-Loading target file C:\Documents and Settings\Administrator\Desktop\JungleFlasher v0.1.62 inc FW Pack\firmware\ix16-benq.bin

Target File MD5 hash is: f36c85c5bfba325b283417f8643d7c27

Genuine Benq iXtreme 1.6

Inquiry string found

Identify string found

DVD key found @ 0xE030 key is 77777777777777777777777777777777

Firmware is Benq OSIG: PBDS VAD6038-64930C

Firmware type is: iXtreme v1.60-12x-FINAL-VAD6038



Spoofing Target

DVD Key copied to target

Inquiry strings identical

Identify strings identical

0xFF00 area copied for Benq to Benq



Target f/w saved as: C:\Documents and Settings\Administrator\My Documents\Benq_CFW.bin



Getting Status from port 0x9400

SPi flash found with Status 0x73



Sending Chip Erase to Port 0x9400

Writing target buffer to flash

Writing Bank 0: ................

Writing Bank 1: ................

Writing Bank 2: ................

Writing Bank 3: ................



Flash Verification Test !

Reading Bank 0: ................

Reading Bank 1: ................

Reading Bank 2: ................

Reading Bank 3: ................

Write Verify Failed !

Sending Vendor Outro to port 0x9400

[commando_lee]

In that it says dvd key is 77777777777777777777777777777777, thats a bad key. If everything plays ok and you dont have a backup of the orginal good key then i would say your 1 lucky person

[calishooter]

So why is my computer acting up when i push benq unlock?(O ya i did save my origanal)

[sadalius]

Where it shows the key of all 7's, thats on the target firmware (ixtreme) prior to spoofing the source to the target. This is normal.

You are using a VIA 6421 to flash with, which for whatever reason, the driver for that card and jungleflasher doesn't really get along very well.

If you are using the VIA 6421 exclusively for flashing, meaning there is nothing else connected to that card, then I would suggest disabling the drivers for the card by doing this.

1. In device manager, disable the card.
2. Go to the driver, usually x:\windows\system32\viamraid.sys and rename the file to something like viamraid.bak
3. Go back to device manager and renable the card. Should show up with a yellow exclamation mark after re-enabling it.

Try flashing again.

[calishooter]

THANX YOU GUYS!!! It was my VIA drivers.Follow the steps from COFEE!

[calishooter]

SORRY!!! I meant SADALIUS!!!!!

[sadalius]

No problem man. Glad you got it sorted. Just keep in mind that if you want to run anything else off that card, you'll have to either re-enable the driver by repeating the procedure above and renaming it back to viamraid.sys or just reinstall the driver all together.