Lite-on Question
-
harley5185
- Squire
- Posts: 47
- Joined: Fri Jan 30, 2009 12:12 am
Lite-on Question
So i have a bad lite-on in my xbox. I want to replace it with a spare benq I have. My question is I have a 64-bit operating system has anything been developed for 64-bit yet? Port IO32 will not work with 64-bit system but I have no problems with Iprep. I ordered a spear usbxtractor for the keys but can't use it because of IO32. What should I do? Just wondering. thanks
Re: Lite-on Question
Have you modded your lite-on before? If so do you still have the key for it? If so read on, if not skip to the 2nd paragraph.
Assuming you still have your key, just build the benq firmware with JF, (yes it will work well enough for 64-bit OS to build the firmware) and slap it on your usb thumb drive built with iprep and then flash with dosflash and not fben.
Assuming you've never modded your drive before, you'll need a CK3 Pro/Lite and a serial (AKA DB-9, RS232) port on your mobo. If you don't have a serial port, you can get a pci serial card, but you'll need the dos drivers from the manufacturer and you have to run them in DOS before you execute dlit.
Assuming you still have your key, just build the benq firmware with JF, (yes it will work well enough for 64-bit OS to build the firmware) and slap it on your usb thumb drive built with iprep and then flash with dosflash and not fben.
Assuming you've never modded your drive before, you'll need a CK3 Pro/Lite and a serial (AKA DB-9, RS232) port on your mobo. If you don't have a serial port, you can get a pci serial card, but you'll need the dos drivers from the manufacturer and you have to run them in DOS before you execute dlit.
Today Money, Tomorrow the WORLD!!