need help with sata?

[grandview]

what do i use if i dont have a onboard sata when using jungleflasher? i have the via chipset but it freezes my computer...

[rkd2398]

I bought a Rosewell RC-212 Sata+Raid Controller Card from Newegg.com

[commando_lee]

i would strongly suggest that you use a sata card that has the VIA6421 chip these are 100% compatable

http://www.shinyhardware.co.uk/prods/sh ... ?pid=10723" onclick="window.open(this.href);return false;

[grandview]

hey commando_lee i have the same one that you have on that picture...look my mobo went out..i was using the onboard sata plugin when i was using JF so it doesnt freeze when using the via chipset...and when i was using iprep i used the via card...but i dont get my new mobo till the 11th of this month..im so backed up on xboxs that i need help....the mobo that im using now doesnt have one....so what do i do now....

[commando_lee]

can you not put your via card on the board that your using now. Disable the drivers when using JF as long as you have the Portio 32 drivers installed you can use JF with out it freezin

[grandview]

so you are saying not to put the via set on the board but what will i use for a sata when hooking up the xbox 360 drive...this board im using doesnt have a sata hook up

[commando_lee]

so you are saying not to put the via set on the board but what will i use for a sata when hooking up the xbox 360 drive...this board im using doesnt have a sata hook up

what im saying is put your pci via card onto the board that you are using now. use iprep to flash the drives. But if your going to use JF you will need to disable the drivers to that card as thats what causes your comp to freeze

[grandview]

so if i disable the drivers...i can still use the sata on the via chipset without it freezing..

[commando_lee]

so if i disable the drivers...i can still use the sata on the via chipset without it freezing..

if you disable the drivers to your card, you can use JF and that shouldnt freeze, but if you do that nothing else apart from the 360 drive wont work untill you enable the drivers. But i would suggest just use iprep to do your flashing then you dont have to disable anything.

[grandview]

thx