Hi All,
My Benq VAD6038 will only open an inch and close an inch...I can grab it and pull it open and closed...but it sounds horrid and I am sure something is going to break.
I am going to buy a replacement drive, and I want to get my current drive key into the new drive.
I have the Ben-OFW file from when I flashed it....IS the drive key stored in this somewhere?
I believe I can just hook the drive up again and run Iprep to get the key if need be.
If there is a tut on this I apologize~!
But any help would be appreciate.
Fatback Out
Benq Tray pooched
-
dalecheesy
- Ally of Robinhood
- Posts: 1379
- Joined: Sat Jan 24, 2009 8:08 pm
- Location: Sunderland UK
Re: Benq Tray pooched
Yeah the drive keys in the ofw. just load it into jungleflasher as the source file and it will auto load the ixtreme. You can either use jungle to do the full lot or save the file and use iprep to finish the flashing off depending on which program you are more comfortable using. Might also be worth taking the lid off your bust one to make sure it's not fouling on somewhere or catching on one of the worm cogs.. I had a samsung sent to me a bit ago and it was down to the drive band getting stretched over time. Could be a simple fix.
