Error when MTK vendor is asked

[azhar7]

I have the samsung ms28. I'm using the latest iprep with the latest firmware. I load up everythin to the usb drive. I disconnect every power inside the pc, so that the 360 drive would b the only detected. iprep loaded up, than comes to vendor. i press yes, the status come up 0x51. power off 360 0xd1. power on back to 0x51.??? wtf. i flashed the benq the other day everythin went swell. but wen it came to the ms28 im havin issues. I need help.

[CoFree]

if its not dropping down
and asking you what drive to use
9that is when i enter the 6 on the video)
then its not able to see or get in the drive for some reason.

here is the guide
http://www.robinhoodsplayground.com/for ... 195&t=5128" onclick="window.open(this.href);return false;

[lilrevuk]

I haven't used iprep in a long time, but it sounds to me like you're having a problem with the firmguard.

try turning the drive on/off with different amounts of time in between ie. turn it off, turn it back on 2/3/4 seconds later.

[azhar7]

I just figure it out. for a samsung flash i had to use a via controller. for the benq i could use any sata controller. so thanks you guys. mod or admin can close this thread.