M25 iXtreme 1.6 will not read originals or backups

[Kuhruby]

This is my third flashed drive. I have flashed a lite-on and a benq with no problems. I'm using a combination of iprep, dosflash, jungleflasher, and firmware toolbox. My M25 will not read originals or backups when flashed with iXtreme 1.6. I have reverted to the stock firmware and it reads original games just fine, so i'm assuming the key is intact. Am I missing something?

[Kuhruby]

Well, I got it to work. I flashed it again and powered the driver off after each step. That seemed to do the trick. If anyone has any input on the matter, I'd still like to know why it didn't work at first. Thanks.

[HaGGardSmurf]

The first time you did not have a valid key in the FW. You must have forgotten to spoof source to target (if you were using JF) or opened the wrong OFW (if you used iPrep)

No originals, no backups = bad key.

I dont think powering cycling the drive after each step made a difference, just a heads up for the future

Good thing its working now though

[Kuhruby]

You're probably right, thanks for the info.