I have the USB drivers it just wont dectect the probe atall. so i got an old RS232 at the moment i have a RS 232 cable from the CK3 pro into back of my PC.
I open Jungle flasher up and still no luck it just gives me a choice of Comport1 ;s
In CK tool when i scan all comports it does not recognise the Probe either on any ports.
The probe works in the fact its blue and goes green when its in the correct point on the dvd drive
agrrhhhh anyone any ideas?
CK3 Probe not being detected
-
dalecheesy
- Ally of Robinhood
- Posts: 1379
- Joined: Sat Jan 24, 2009 8:08 pm
- Location: Sunderland UK
Re: CK3 Probe not being detected
Err i'm a bit confused. The probe isn't meant to show up in jungle or iprep it's just used for dumping the drive.
Re: CK3 Probe not being detected
IT should show up on comport and give me the ability to tick the Box to use it according to the Tutorials?
-
commando_lee
- Ally of Robinhood
- Posts: 1821
- Joined: Sun Apr 26, 2009 12:50 pm
- Location: Up high in the tree looking out for the Sheriff of Nottingham
Re: CK3 Probe not being detected
the porbe should show as prolific usb serial device or somethin like that.
check that you have the correct drivers for it to show in JF,
Iprep you dont need any drivers just your rs232 cable and when setting iprep up make sure you have the correct com port
check that you have the correct drivers for it to show in JF,
Iprep you dont need any drivers just your rs232 cable and when setting iprep up make sure you have the correct com port
................................................................RobinHoods Very Own
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.