I bought a pci sata controller card
I have done everything accord to every guide and i just cant make this "bad word" thing be detected >_>
Any suggestions?
I am using Iprep and when it get to detecting the Drive to dump it detect not ATAPI Devices. Any suggestions of help would be appreciated.
I can Get computer To detect drive
-
commando_lee
- Ally of Robinhood
- Posts: 1821
- Joined: Sun Apr 26, 2009 12:50 pm
- Location: Up high in the tree looking out for the Sheriff of Nottingham
Re: I can Get computer To detect drive
do you have the right controller selected in the drop down bar in iprep??
also do you have the sata cable plugged into the primary port and not any others on the card??
also do you have the sata cable plugged into the primary port and not any others on the card??
You do not have the required permissions to view the files attached to this post.
................................................................RobinHoods Very Own
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.
-
nufcmickey
- Trusted Member
- Posts: 284
- Joined: Wed Feb 25, 2009 10:05 pm
- Location: North East of England, UK
- Contact:
Re: I can Get computer To detect drive
Mine wasnt there either on initial first look but try changing it to IDE based like I had to, Then if you click the dropdown you should then see your sata controller.