iPrep 10 loading issues

[Shootsteel]

I have installed the NEW iPrep and went to run it.....

I get the error "no valid firmware loaded" when I try to load the 7000 lite-on or the 8000 lite-on it loads samsung and Benq just fine.

I know my firmware is correct as I have flashed both drives (7000/8000 series lite-on) am I holding my mouth wrong over here?

Rats...I am so excited I just want to flash the 8000 with iPrep.

[sadalius]

It loads fine fw's fine for me. Check your ixdef.xml file and compare the md5 checksums to see where the problem might be.

[sadalius]

Did you get this figured out shootsteel?

[HaGGardSmurf]

The only thing could be the md5's Open the idef file with notepad, and look for the FW in the list.