jungle flasher and iPrep with liteon 83850C

[killthealiens]

I've been having trouble with both Jungle flasher and iPrep, I don't know if I'm doing some wrong, but that doesn't seem like it. I tried Jungle flasher first, and I was able to extract the 3 .bins before the whole program froze on me which is a problem a lot of people have been having. So I tried iPrep 10.7, I make a bootable USB drive, but it gives me an error "remove disks and other media, press any key to restart". This is another problem a lot of people have been running into. I also tried the iprep 0.9 with updated definition, but that too gave me the error. So what can I do now? Are there any other ways to hack a liteon 83850C? Thanks.

[dalecheesy]

Try a smaller usb stick (anything under 2 gb is recommended) and also try booting it with FAT and FAT32 as your motherboard may only support one or the other. My old board would only boot with fat formatted sticks.

[killthealiens]

I'll try that, and it's a 256mb drive.

edit: Still getting the same error.

[dalecheesy]

In that case i'd try formatting it in the other fat. Give it a whirl and keep us posted.

Edit. Have you got another stick you could try? You can also use a psp in usb mode or an sd card in a reader if you have one kicking about. Also worth going into your bios and checking legacy mode is enabled.

[killthealiens]

Well I would think this one would work. DosFlash was able to make it into a bootable USB, and it worked fine.

Legacy Devices are enabled.

[killthealiens]

anymore suggestions?

[warship]

I flashed my first liteon 83850c this morning after reading the tutorials by Cofree went smooth as silk .Can you give us a rundown of your hardware you have installed .

[killthealiens]

I'm using the VIA 6421 PCI card if that's what you're talking about.

[killthealiens]

is there anything I can do with the Dummy.bin, Inquiry.bin, and Identify.bin I have?