replacing spoofed sammy with benq

[wulfie]

Hey guys, I'm going to try to replace my spoofed sammy with a new benq, I'm having issues with jungleflasher and the dreaded via lockup, I think it's due to a conflict with my onboard ide raid, so I'm going to give iprep a shot. My question is this, can I use iprep to dump my sammy, and then use jungleflasher to make the firmware and then use iprep to flash it? If so, what steps should I take? Any and all help would be greatly appreciated. Also, can I use a pci usb card for iprep? The reason I ask is cause the onboard usb is only usb1.1, and I prefer usb 2.0

[CoFree]

i would use jungle flasher to build the hacked firmware
if you have a copy of you orig firmware load that as source firmware
then load in the drive firmware you are going to be spoofing into the console

then back to iprep and flash like a restore

it will not be a problem to boot on a usb1 as long as your pc will do it

i would not usc a pci card just for that

have a look over this
http://www.robinhoodsplayground.com/for ... p=542#p542" onclick="window.open(this.href);return false;
the only thing is you will be using you new spoofed hacked firmware that you rename to flash in