BenQ iXtreme 1.61 - Activate ISO Issue

The place for more technical questions about modding your Xbox 360!
Locked
IllFateFlaw
Peasant
Peasant
Posts: 2
Joined: Mon Nov 02, 2009 3:41 pm

BenQ iXtreme 1.61 - Activate ISO Issue

Post by IllFateFlaw »

I was running my box on ixtreme 1.6. I ran the activate iso, the xbox update popped up - failed the first time and prompted me to redo the download upon rebooting. It seemed to install OK. After restarting the box i inserted the activate iso disc. It came up play dvd. So far so good, Removing the activate iso, and inserting cod mw 2 disc it brings the big game pic up in the but not the mini pic. When i go to play it it tries to read for a few sec and then says clean disc first with no background and then when you accept it prompts you again with the same clean disc - this time with your dashboard semi transparent in the background. I have burned multiple disc on good media at low write speeds. I have a huge collection of games with no issues ever. I then updated the firmware to ixtreme 1.61 and still no luck with or without the activate iso disc. Also i have downloaded the same game from 2 different sources to verify it was not a bad iso. As for the activate iso its on a DL disc, set to burn on layer 0 and have tried both with and without the layer break set.

Anyone else with the same issue? I fear that wave 4 update messed something up :s
sweet67aircooled
Peasant
Peasant
Posts: 1
Joined: Sat Mar 07, 2009 11:44 am

Re: BenQ iXtreme 1.61 - Activate ISO Issue

Post by sweet67aircooled »

yea i have the same issue reads activate iso disk i switch to game wave 4 doesn't recognize it as a game just says play dvd. put in older game pops just fine. Flashed my other box sammy works fine using iprep.
IllFateFlaw
Peasant
Peasant
Posts: 2
Joined: Mon Nov 02, 2009 3:41 pm

Re: BenQ iXtreme 1.61 - Activate ISO Issue

Post by IllFateFlaw »

Well in my case it will say play game with the big game pic and then a blank lil game pic. The option to download the game to the hd is not avail (which i have read that the elite wont be able to anyways) . Im pushing towards a bad burn with imgburn 2.5.0.0 but i cant see it happening over 4 discs especially when i can burn wave 3 OK. Im downloading Tekken 6 now to see if that burn works.
iamwatt
Ally of Robinhood
Ally of Robinhood
Posts: 875
Joined: Wed Jan 21, 2009 5:50 pm
Location: new york

Re: BenQ iXtreme 1.61 - Activate ISO Issue

Post by iamwatt »

smh! first we don't support downloaded games. . . second, for someone with a huge collection of games an issue like this shouldn't be hard to figure out, there have been a number of wave 4 games released recently and third, i doubt that mw2 rip is good because it's really not that hard to use the activte iso.

thred locked guys. . .
Locked

Return to “360 DVD Drive Flashing”