LITE-ON Help with iprep 10.7

[stevio1973]

Please help me get my sons xmas present up and running.

Recently I flashed my LITE-ON 74850 c, I realised as a noob that |I had flashed it with iextreme for 83850 c, when I put the drive in the unit I just got the open tray message and the green light flashing constantly, I removed the drive to reflash and may of erased the drive, now i can't detect the drive, I have not fried the drive and still have my dummy, inquiry, identify and key files. I can't detect the drive in jungleflasher, dos 32 or in iprep. I get the 0x7F all the time, I am putting the tray into vendor mode but just not detecting, since my error I have flashed two further Lite-on 74850 c drives with no issues, Please help me !

[rey39]

u put the wrong firmware on it,as long as u have your orig firmware u are fine just use iprep to write the orig firmware on it then flash it,use iprep 009 to write the orig firmware and then use iprep 10.7 to flash it with the 838 firmware if u need help just hit me up and i will help u later....bro

[stevio1973]

Please please help me man, I tried iprep 9 but still no joy as my drive is undetected

[fenixsaint]

Here is the guide to flash a bricked 74850c
http://robinhoodsplayground.com/forum/v ... 197&t=7041" onclick="window.open(this.href);return false;

[stevio1973]

Tried that to the letter but i get the bad filname error message all the time

[fenixsaint]

at which step are you getting the bad filename error message? And did you try using the command "l74 1234567 12345 w" with the modified firmware in the proper folder?

[stevio1973]

At the command prompt stage I typed in flit 1234567 12345 and got bad filename, I saved my CFW in the folder backups\1234567\12345 as litcfw.bin is there something else for me to try?

[fenixsaint]

The command flit you are using is for the old version of iprep 9. The command you should be using for iprep 10.7 is "l74 1234567 12345 w"

[stevio1973]

Soz mate i was using that command in 10.7 which did not work then you suggested following the tut which was using iprep 9 and the flit command which still did not work

[fenixsaint]

Hmm.....

Since you flashed it to a l83 earlier maybe you could try the command l83 1234567 12345 w. I read that just plain 1234567 12345 w would work as well but I haven't tried that one. I'm running out of ideas.

Could you write down the error message in full and post it?

Edit: Stupid question I'm sure, but is the drive half open when you go to write in iprep?

[stevio1973]

Will do just put the kids to bed and I'll give it a shot

[stevio1973]

I get the 'No ATAPI drive found on this port' prompt when in vendor mode, thats my problem I just can't seem to get the dam thing recognised