first flash with 1.61 on benq

[shaky]

trying to flash a benq with new iprep and 1.61 , i followed the vid but i am getting error message after reading banks

[CoFree]

try a different usb flash drive and
make sure you are on a via6421a or l chipset

[shaky]

my card is a VIA6421a on the box but when i open iprep in sata controller it says VIA VT6421 and my old mem stick is a 1gig my new one is a 2gig does that matter or not

[CoFree]

2gb is fine but try not to use one larger than that

[shaky]

so why am i getting error then it wont go past reading banks

[CoFree]

man you will need to go into detail about what you ae doing and when it gives you the error
have you got a good dump of your firmware and you get the error when firmtool is going to start

[shaky]

sorry my friend here goes , boot from mem stick type ben mel1 mel1 etc
this is the screen i am getting
reading banks 0
reading banks 1
reading banks 2 etc etc
reading banks finished datasum b84f
57697----------------------------------
firmtool v1-3-1 by caster420
no valid key found
check key range of backups
error
drive firmware reading failed
double check your conection and try again

[shaky]

come on help please why am i getting this error

[djshauny1]

come on help please why am i getting this error

man when people are ready to answer they will.
shouting like that wont get u help im affraid

[shaky]

come on help please why am i getting this error

man when people are ready to answer they will.
shouting like that wont get u help im affraid

sorry mate i wasnt shouting just in a hurry to get it sorted
i have followed all instructions even changed my mem stick but sill getting erors