Hello, I have run into some trouble when trying to flash my Liton to latest 1.7 IExtreme firmware.
I have my Lite-on Drive 74850C connected to my pc with Xecuter CK3 lite and CK3 Probe. Everything worked i managed to dump the firmware key,inquiry,identify,serial,dummy.bin. In the Firmware Tool section in Jungleflasher I Added the source Firmware did the spoof added the LT 1.7 firmware and saved it.
I think this was my big misstake after that i proceeded to do the Lite-on Erase and obv it failed. Now i cant eject the dvd tray anymore. I have read on some forums that you can actually use Iprep to install orginal firmware back to your Lite on and get it working that way. Now the problem is I don´t really have an orginal firmware or i added the destination firmware in the first step right of the bat. So when i Open that file it says Firmware type IExtreme LT. I have tried in several versions of ipred to get a flash file going but i always get this error message "No vailid firmware loaded". And I think thats because the firmware i saved down with JungleFlasher is not vieved as "orginal" anymore?
But anyway i have the 5 files from the dump is there any way to create an orginal firmware from scratch to get my Drive back responding? Or what actions do you recommend me taking now?
-CoffeyMan
Lite-On 74850C Driver Lite-On Erase Error in JungleFlasher
Re: Lite-On 74850C Driver Lite-On Erase Error in JungleFlasher
Happened to me too, so don't worry, and I got it working again (thanks to Cofree).
Just follow Cofree's tutorial and you'll have it up and running in now time.
http://robinhoodsplayground.com/forum/v ... 195&t=3226
Just follow Cofree's tutorial and you'll have it up and running in now time.
http://robinhoodsplayground.com/forum/v ... 195&t=3226
Re: Lite-On 74850C Driver Lite-On Erase Error in JungleFlasher
Hey there Sorry for no earlier response.
I had hardtime to get IPREP to accept my firmware from Jungle flasher.
Anyway I went into the Jungleflasher chat room and there i got the advice from them to try power cycle then Hit INTro device button in MTK flash and if i could get some certain Device Ids up i was good to go with Flashing. And my device ids was good so then i could flash and voila now its all fine
.
Anyway its a few days ago but thats the procedure in a nutshell. I have not seen this procedure posted anywere just that u need IPREP to recover these kind of problems. But u can actually do it with JungleFlasher too.
I had hardtime to get IPREP to accept my firmware from Jungle flasher.
Anyway I went into the Jungleflasher chat room and there i got the advice from them to try power cycle then Hit INTro device button in MTK flash and if i could get some certain Device Ids up i was good to go with Flashing. And my device ids was good so then i could flash and voila now its all fine
.Anyway its a few days ago but thats the procedure in a nutshell. I have not seen this procedure posted anywere just that u need IPREP to recover these kind of problems. But u can actually do it with JungleFlasher too.