Erased Liteon Iprep won't load FW

[dustman1995]

Hey guys,
Erased my liteon with JF and of course it froze up, (even with my new setup) very disapointing. So I have the hacked Lite_CFW.bin file built with the new LT firmware. Now when I go to load it into Iprep 11.6, it gives me an error that says

' A valid firmware source was not selected
Only Non-Patched firmwares can be loaded'

Can someone please point me in the right direction?

[dustman1995]

Ok, here's what I did so far. I opened up the usb bootable drive and manually put in hacked firmware with the key into that folder. and in the backup folder 1234567/12345/ put the L74 CFW.bin in that was loaded previously from IPREP 11.6 then did write only. It brought my drive back to life, as in I can nowopen and close thetra but it won't play games. I'm doing something simple wrong butI don't know what it is. Help.

[cainhunpi]

when I froze mine I used this tutorial

http://www.robinhoodsplayground.com/for ... 197&t=7041


It would not work with iprep 11, I had to find a copy of iprep 9 in some website that I can't remember right now

[dustman1995]

IPREP 9. OK I'll try that. If it doesn't load the new LT I'll just put in 1.6 CFW . Thanks

[Baja]

when you stick the cfw into the folder on ur flash drive, r u replaceing it and renaming it with the cfw thats in the folder? i had this happen a few weeks ago and turned a drive into a vegetable but the key is to replace the cfw file with the 1 u patched in jf that way iprep finds that 1 for the flash afterwards, do a re-read and confirm that file in jf to make sure its all up to snuff

[Vdizzle]

Im having the same issue and have been trying various things for hours!

In Iprep am i supposed to load the .bin i have created in JungleFlasher? If so get the same error below each time:

"A valid firmware source was not selected
Only Non-Patched firmwares can be loaded"

I tried to skip this stage (as i wasnt 100% i had to do this) and made a bootable usb with the bin file in the correct folder 1234567>12345

But when i ran L74 1234567 12345 W i am told that this is an invalid command!

Any ideas? any help? Would be much appreciated.

[Vdizzle]

Sorry people. Sorry to be a pain and my first post to be begging for help but i'm completely at a loss for what to do.

Any advice would be welcome.

Thanks