falcon jtag ?

[johnnykilla]

ok i got two units i am jtagging both have 2 red lights
i got the falcon solder in but it is getting errors when i run nandpro20
what am i doing wrong in the pic below i got the yellow wire going to point on bottom of board
also wondering what size screw do i use for x clamp please and thank you
trying to get both units back up got two red lights on both

[technoe]

Well, you don't run the wire to the actual rf board, just the contact for it on the bottom side of the mobo. After that, the only other thing I can think of is making sure, you're not shorting out the leads on the bottom side of the board by touching the metal casing. If your leads are too long you will get a ton of errors in nandpro. Also make sure you're not trying to dump more than the board has, this will lead to errors as well. IE: Don't use nandpro lpt: -r512 nand1.bin, if you only need nandpro lpt: -r16 nand1.bin.