I dont get it.... or do I?

[shlomes]

The drive was flashed with iXtreme LT 1.0 and its a LiteOn 74850C in this case.
Do i understand it right, that i cant get any key from the drive anymore cause of LT but can use the old dummy.bin to flash it with LT 1.1.
To my understanding, because i didnt use the MRA method or the xecuter lt switch to obtain the orig.bin/dummy.bin the calibration data is lost and not reriveble any more (which dosnt make a difference?!?!)
So:
1. can i flash LT1.1 to LT1.0 using old dummy.bin
2. there is no point in doing MRA or swich methode now cause data is lost anyways.

Thanx guys in advance.

[louisM92]

forget about dumping the drive first, open dummy as source, LT 1.1 as target, spoof source to target, flash like normal

[commando_lee]

Louis is right, create the hacked fw with your key then just flash. that way no need to dump the drive

[Deathuntou]

Hi a lot of friends have been asking about this topic i wasn't sure of the answer, so I thought I would try the experts on the subject. Doing as you describe here is that putting your firmware back to stock to allow for the update or is that just getting 1.1 ready to flash to the system? thanks.

[shlomes]

Thanx guys for the info.

[louisM92]

Hi a lot of friends have been asking about this topic i wasn't sure of the answer, so I thought I would try the experts on the subject. Doing as you describe here is that putting your firmware back to stock to allow for the update or is that just getting 1.1 ready to flash to the system? thanks.

I believe people want to revert to stock so when the update is alplyed to their console microsoft dont have reports back that the drive is flashed (BANNED!), then after the update they flash back to hacked firmware, thats just what i THINK not what i KNOW