93450c flash broke 2 pads HELP !!!!

[loady]

I encountered my first one of these drives and whilst my soldering is fairly good in my stupidity i used single core wire i had to hand to use as the jump leads and connections instead of copper stranded wire, this has resulted in the wires when moved pulling off the pads from two locations on the board, i have circled them in red, the first pad to go was the one i know to be pad 101, apparently this can be reconnected using a different point but what about the other pad, is it possible to connect this back up using another point on the board...your help as ever is really appreciated.