am i screwed? is there any way to save this drive w/out the key?(doubt it) to be honest dont even know if i properly cut the traces , i mean i followed j/flash tut on where to cut etc., is there some1 who can correct my mess? (obviously for a fee) failed mra hack
failed mra hack
well, cant say it was from lack of trying..... i attempted the mra hack but no luck. status 0x52 ,locked drive, no dvd key am i screwed? is there any way to save this drive w/out the key?(doubt it) to be honest dont even know if i properly cut the traces , i mean i followed j/flash tut on where to cut etc., is there some1 who can correct my mess? (obviously for a fee)
am i screwed? is there any way to save this drive w/out the key?(doubt it) to be honest dont even know if i properly cut the traces , i mean i followed j/flash tut on where to cut etc., is there some1 who can correct my mess? (obviously for a fee) 
Re: failed mra hack
well the drive should be fine
it should not be erased
if it dont work it has to be a solder joint you have not fixed
try to take some good pictures and post them so i can see what has happened and we will go from there
it should not be erased
if it dont work it has to be a solder joint you have not fixed
try to take some good pictures and post them so i can see what has happened and we will go from there
"FIGHTING TYRANNY in a TECHNOLOGICAL NOTTINGHAM"
No Questions by PM.
No Questions by PM.